Here’s what you’ll need to make this vase yourself

Posted on

 

Pringles container
Leak Seal rubber coating
Rocks
3M Super Spray Adhesive
Grout
Sponges
Paint Brushes
Water
Paper towels
Mod Podge

For the first couple of steps, I suggest you work either outside or in a workshop where you feel comfortable spraying the sealant and glue adhesive.

Step 1: Spray the rubber seal coating inside the can to seal it to prevent water leaks.

Step 2: Turn your can on it’s side and spray a section of glue. Then start placing rocks in a pattern that’s pleasing to you. Repeat this step across the entire can until you’ve completely covered it with rocks. Let dry.

Step 3: After your glued rocks have dried, using a knife start spreading on the grout in sections. I layered the grout all the way down the length of the can. Then, before the grout dries, start to rub the grout off as much of the rocks as you can while at the same time pushing the grout in between the rocks. First I rubbed off the grout with a paper towel, then I took some water on a paint brush and brushed around and across the rocks. Then finally I took a moist sponge and rubbed the rocks down again. Repeat this process until you’ve grouted the whole container

Step 4: Once the grout has dried, (usually after a night), layer the grouted rocks with some Mod Podge to create a shiny surface.

Step 5: When the Mod Podge has dried, fill the container with water and your favorite flowers.

Step 6: Step back and admire your amazing work!